Spray 400ml injection system cleaner, valves and butterflies liqui moly pro line for motorcycle moped spare parts

€28.99
Spray 400ml injection system cleaner, valves and butterflies liqui moly pro line for motorcycle spare parts moped accessories
Quantity

  • Buy and pay securely with our SSL gateway using Visa, Mastercard and/or Paypal Buy and pay securely with our SSL gateway using Visa, Mastercard and/or Paypal
  • Shipments in less than 48 hours by urgent and insured agencies. Shipments in less than 48 hours by urgent and insured agencies.
  • Up to 30 days for returns, contact us to resolve any issues. Up to 30 days for returns, contact us to resolve any issues.
PayPal

For the area of the inlet and throttle valves, including the injectors and passages. Only suitable for use in gasoline engines.

Special active solvent for cleaning typical deposits and dirt that form in the area of inlet and throttle valves. Dissolves and eliminates all types of contaminating substances and viscous deposits, such as oil, resin, glue residue, etc. It guarantees the operation of moving parts and reduces fuel consumption. Increases the operating safety of gasoline engines.

Application

Get direct access to the throttle valve. Start the engine to start cleaning. If, with the intake pipe separated, the engine cannot maintain the number of revolutions or cannot be started, disconnect the plug from the air mass meter with the ignition off. In this case, after cleaning, the fault stored in the engine control unit must be erased with suitable diagnostic equipment and, if necessary, the air mass meter must be reprogrammed. Spray Butterfly Valve Cleaner over the entire area of the butterfly valve using the spray probe at a medium speed (min. 2000 rpm). If revolutions of more than 1000 revolutions occur during application, it is important to reduce the spray intervals. Please note that the throttle valve cleaner must not come into contact with the air mass meter or painted components. In case of persistent sediment on the throttle valve, intake manifold or intake valves, the application can be repeated with another can. After application, run the engine for approx. about 20 more seconds at 2000 revolutions so that any residual quantity that may be in the intake system can be burned.

LIQUI MOLY
VM20200052